Nearly all of the time, businesses would spend lots of money to purchase their lift trucks. It is important, therefore to take good care of your machine to protect your investment into the long run. It is a great idea to know the procedures that are undertaken in maintaining and taking care of this machine.
By starting up the forklift and listening carefully how it runs is among the best ways to tell how good the engine is performing. Like for example, if there are any misses or knocks, the equipment is defective and this should raise some issues. Furthermore listen carefully for any squealing noise that come from the belts since these noises will provide you with a lot of information.
Several of the main components needing attention during maintenance comprise the safety warning devices, gauges, horn, the lights and the overhead guard. Any burnt out light bulbs or faulty components must be replaced as soon as they are noticed. It is also vital to inspect the wiring.
When the above components have been checked carefully, proceed to the battery compartment in order to see if the terminals are clean. If the terminals are not clean, be sure to clean them well. Every battery cell should be checked so as to make sure that the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the machinery and after that change the filters. The hydraulic filter, the transmission filter and the fuel filters need to be replaced regularly. Before fitting them, be sure to write the date on the new filters by using a permanent marker to be able to keep track.
After the oil change is finished and the filters have been replaced, a visual inspection of the drive axle has to be performed. If there is a grease fitting on the axle make sure to apply some grease. Check the engine belts for any frays or cracks. If you find any, fix the problem accordingly. Next, check every other component of the machinery like the wheels. If any kind of fault or issue is detected, be sure to address it immediately in order to make sure the equipment is working at its safest and optimum levels.